线缆-机箱电磁兼容分析的PEEC-MoM混合方法

doi:10.3969/j.issn.1001-2400.2016.06.025

西安电子科技大学学报

线缆-机箱电磁兼容分析的PEEC-MoM混合方法

杨福荣1,2;李鹏1;许万业1;魏茂刚2;李勋1

(1. 西安电子科技大学电子装备结构设计教育部重点实验室，陕西西安 710071;
2. 西南电子设备研究所，西川成都 610036)

收稿日期:2015-11-10 出版日期:2016-12-20 发布日期:2017-01-19
作者简介:杨福荣(1989-)，男，工程师，E-mail: xiaosu_mcu@163.com．
基金资助:
国家自然科学基金资助项目(51490660)；国家自然科学基金面上资助项目(51475348)

PEEC-MoM hybrid method for electromagnetic compatibility analysis of the cable-enclosure system

YANG Furong1,2;LI Peng1;XU Wanye1;WEI Maogang2;LI Xun1

(1. Ministry of Education Key Lab. of Electronic Equipment Structure, Xidian Univ., Xi'an 710071, China;
2. Southwest China Research Institute of Electronic Equipment, Chengdu 610036, China)

Received:2015-11-10 Online:2016-12-20 Published:2017-01-19

摘要/Abstract

摘要：

针对线缆-机箱系统的电磁兼容性问题，提出了一种部分元等效电路法与矩量法混合的数值分析方法．利用部分元等效电路法建立线缆、电连接器和内部印刷电路板的等效高频电路模型，通过电路分析方法得到其激励特性，并基于能量守恒定理将其等效为辐射偶极子天线，最后加入矩量法分析的机箱屏效模型中，进行内部电路板信号完整性分析和机箱屏效计算．机箱内部印刷电路板信号完整性分析结果与商用软件微波仿真工作室的计算结果吻合良好，线缆机箱屏效实验测试结果与分析结果同样吻合良好，计算精度满足电磁兼容工程分析的需要，表明了文中所提方法的有效性．

关键词: 线缆机箱, 电连接器, 部分元等效电路法, 信号完整性, 屏效

Abstract:

For the EMC problem of a cable(with connector)-enclosure(with PCB) system, a hybrid numerical analysis method for the partial element equivalent circuit (PEEC) and the method of moment (MoM) is proposed. The PEEC is used to model the cable-connector-PCB, and the electromagnetic properties could be calculated by the circuit method. Based on energy conservation, the cable-connector is replaced by an equivalent dipole which has similar electromagnetic radiation properties. The equivalent dipole is added to the model of the enclosure which is analyzed by the MoM. Then the shielding effectiveness of the enclosure and the signal integrity of the PCB in the enclosure can be obtained. An experiment is designed to verify the proposed hybrid method. The test results and simulated results are in good agreement. This hybrid method could be used to calculate not only the signal integrity of the cable and PCB, but also the shielding effectiveness of the cable-enclosure system.

杨福荣;李鹏;许万业;魏茂刚;李勋. 线缆-机箱电磁兼容分析的PEEC-MoM混合方法[J]. 西安电子科技大学学报, 2016, 43(6): 147-151+157.

YANG Furong;LI Peng;XU Wanye;WEI Maogang;LI Xun. PEEC-MoM hybrid method for electromagnetic compatibility analysis of the cable-enclosure system[J]. Journal of Xidian University, 2016, 43(6): 147-151+157.

参考文献

［1］孔繁, 王昊, 盛卫星, 等. 基于三角面元剖分的全波信号完整性建模方法［J］. 电波科学学报, 2012, 27(3): 489-495.
KONG Fan, WANG Hao, SHENG Weixing, et al. Full Wave Single Integrity Modeling Approach Based on Triangle Meshes［J］. Chinese Journal of Radio Science, 2012, 27(3): 489-495.
［2］ SAFAVI S, EKMAN J. A Hybrid PEEC-SPICE Method for Time-domain Simulation of Mixed Nonlinear Circuits and Electromagnetic Problems［J］. IEEE Transactions on Electromagnetic Compatibility, 2014, 56(4): 912-922.
［3］ KOVACEVIC I F, FRIEDLI T, MSING A M, et al. Full PEEC Modeling of EMI Filter Inductors in the Frequency Domain［J］. IEEE Transactions on Magnetics, 2013, 49(10): 5248-5256.
［4］ WOLLENBERG G, KOCHETOV S V. Fast Computation of Radiated Power Distribution in Coupled Wire Systems by the PEEC Method［C］//2003 IEEE International Symposium on Electromagnetic Compatibility. Piscataway: IEEE, 2003: 1152-1155.
［5］ YEUNG L K, WU K L. PEEC Modeling of Radiation Problems for Microstrip Structures［J］. IEEE Transactions on Antennas and Propagation, 2013, 61(7): 3648-3655.
［6］ CAO Y S, JIANG L J, RUEHLI A E. Distributive Radiation and Transfer Characterization Based on the PEEC Method［J］. IEEE Transactions on Electromagnetic Compatibility, 2015, 57(4): 734-742.
［7］初秀琴, 卢珊, 秦俊, 等. 过孔激起反谐振信号对信号传输的影响［J］. 西安电子科技大学学报, 2013, 40(5): 135-140.
CHU XiuQin, LU Shan, QIN Jun, et al. Analysis of the Effect of the Anti-resonance Inspired by via on PCB on Signal Transmission［J］. Journal of Xidian University, 2013, 40(5): 135-140.
［8］刘恩博, 杜平安, 周元, 等. 以PCB为干扰源的带孔机箱电磁辐射特性仿真研究［J］. 电子学报, 2015, 43(3): 611-614.
LIU Enbo, DU Ping'an, ZHOU Yuan, et al. Numerical Simulation on the Electromagnetic Radiation Performance of Enclosure with Apertures Excited by PCB［J］. Acta Electronica Sinica, 2015, 43(3): 611-614.
［9］ YENIKAYA S, AKMAN A. Hybrid MoM/FEM Modeling of Loaded Enclosure with Aperture in EMC Problems［J］. International Journal of RF and Microwave Computer-aided Engineering, 2009, 19(2): 204-210.
［10］ BOUTAR A, REINEIX A, GUIFFAUT C. A Very Efficient Analytical Approach for Electromagnetic Field to Transmission Line Coupling in Shielded Enclosure［C］//Proceedings of the 2013 IEEE International Symposium on Electromagnetic Compatibility. Piscataway: IEEE, 2013: 270-275.
［11］ OBIEKEZIE C, THOMAS D W P, NOTHOFER A, et al. A Technique for Analyzing EMC Shielding Effectiveness Based on Near-field Measurement and Equivalent Dipole Modeling［C］//Proceedings of the 2013 IEEE International Symposium on Electromagnetic Compatibility. Piscataway: IEEE, 2013: 699-704.
［12］孔繁, 盛卫星, 马晓峰, 等. 高速背板互连的信号完整性仿真方法［J］. 系统工程与电子技术, 2014, 36(10): 2082-2088.
KONG Fan, SHENG Weixing, MA Xiaofeng, et al. Signal Integrity Simualtion Method for High-speed Backplane Interconnection［J］. Systems Engineering and Electronics, 2014, 36(10): 2082-2088.
［13］ YUAN W L, LI E P. A Systematic Coupled Approach for Electromagnetic Susceptibility Analysis of a Shielded Device with Multilayer Circuitry［J］. IEEE Transaction on Electromagnetic Compatibility, 2005, 47(4): 692-700.
［14］ EKMAN J. Electromagnetic Modeling Using the Partial Element Equivalent Circuit Method［D］. Hulea: Lulea University of Technology, 2003.
［15］ NABORS K, KIM S, WHITE J, et al. FastCap USER'S GUIDE ［R/OL］. ［2015-06-18］. http://data.eefocus.com/myspace/36/…/1272054714_ad869a21.pdf.

[1]	佟星元;朱樟明;杨银堂;孔亮. 信号完整性设计中的抖动与振铃消除技术[J]. J4, 2012, 39(6): 136-141.
[2]	高崧;李玉山;闫旭. 一种补偿宏模型无源性的快速凸优化方法[J]. J4, 2012, 39(1): 62-66+121.

线缆-机箱电磁兼容分析的PEEC-MoM混合方法

PEEC-MoM hybrid method for electromagnetic compatibility analysis of the cable-enclosure system

PDF (PC)

赞

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 2

Metrics

本文评价

推荐阅读 10