Journal of Xidian University ›› 2019, Vol. 46 ›› Issue (3): 140-147.doi: 10.19665/j.issn1001-2400.2019.03.021

Previous Articles     Next Articles

Design of an ADC with the submicron process for micromechanical accelerometers

YU Jianhai1,YIN Liang2   

  1. 1. School of Electronic and Information Engineering, Wuzhou University, Wuzhou 543002, China
    2. MEMS Center, Harbin Institute of Technology, Harbin 150000, China
  • Received:2018-12-27 Online:2019-06-20 Published:2019-06-19

Abstract:

A 16 bits high-order ∑Δ analog-to-digital converter is proposed based on the submicron process to meet the application requirements for the digital output of high-performance micromechanical accelerometers. The fifth-order feedforward single bit quantization topology is adopted to achieve the low-distortion analog-to-digital converter output. The front-stage integrator adopts the gain-enhanced folded-cascode operational amplifier structure to improve the low-frequency gain and reduce the influence of gain nonlinearity on analog-to-digital converter distortion. The optimization of the integrator output swing and the application of the switched-capacitor common mode feedback circuit reduce the overall power consumption. Test results show that the distortion is lower than 90dB when the sampling frequency is 8MHz and a little higher than 90dB when the sampling frequency is reduced to 4MHz for the low power dissipation mode. This high integration and large dynamic range fifth-order feedforward sigma-delta analog-to-digital converter topology achieves 16 bits resolution, and it can be applied for digitizing the output signal of micromechanical accelerometers.

Key words: micromechanical accelerometer, sigma-delta analog-to-digital converter, low-distortion, gain-enhanced folded-cascode

CLC Number: 

  • TN4

Baidu
map